【product description】
FRP polishing wax is a new type of high-efficiency grinding product. At the same time, the three functions of removing marks, polishing and maintenance are integrated into one, and one process can complete the effect of the original three processes. This product does not contain silicon and silicon compounds, and there is little dust during construction. After use, the surface forms a protective film to protect and restore the bright and dazzling effect of the painted surface.
【The main purpose】
For all resin surface paint film polishing, defect repair, glazing maintenance. Especially suitable for high-grade paint film. It can quickly repair the defects of high-concentration paint film caused by operation errors.
◆ Quickly remove the sanding marks of 2000 grit sandpaper and repair the paint surface.
◆ Remove defects on the surface of the paint film due to dust particles, sagging, overspray and orange peel.
◆ Repair the oxidized old surface layer of the paint film and restore the high gloss of the paint film.
【Instructions for use】
1. First clean the surface to be polished (partial polishing, you can only clean the area that needs polishing).
2. If you want to remove deep scratches, first use 3M2000# water sandpaper for sanding. When the sandpaper is finished, you should use water or a wet towel to clean the dirt from the sandpaper. Do not allow dirt to remain on the painted surface.
3. Rub the wax evenly on the surface to be polished with a coarse wool wheel (or cloth wheel) (if the polishing area is too large, the workpiece should be divided into multiple parts and operated one by one according to the local area, and the workpiece must not be removed first. Polishing after rubbing, because the liquid in the operation wax will volatilize, and there will be a large dust phenomenon during polishing).
4. Use the polishing machine with the rough wheel (or cloth wheel), the surface of the polishing disc must be clean, and no other substances can adhere to it.
5. The fastest speed of the polishing machine is recommended to be within 5th gear (speed within 1200~2500 rpm).
6. Until the wax is completely collected, the brightness comes out, and the scratches are smoothed, the next local area can be applied.
7, and so on to do the polishing of the finished parts.
